Rockwell Automation FactoryTalk Historian SE ProcessBook 3.2 User Guide - Manual (Page 236)

●
●
●
●
●
FactoryTalk Historian ProcessBook User Guide
218
Configure the Flow Tab
To configure the Flow tab:
1. In Build mode, open the Connectors dialog box (page 216). The Flow
tab is in focus.
2. In the Connector drop-down box, select a Connector. Connectors are
numbered; you can find a ToolTip on the display to identify each one.
In the Source and Destination boxes, you will see highlights for the
current Connection Points for that Connector.
3. Modify the Flow Direction if you wish.
4. Click a new Connection Point on the Source tree to change the
Source Connection Point.
5. Click a Connection Point on the Destination tree to change the
Destination Connection Point.
6. Click Apply. This changes the display.
7. Repeat these steps for all Connectors on the display that you wish to
modify.
8. Click OK. If the display is satisfactory, save it.