Rockwell Automation FactoryTalk Historian SE ProcessBook 3.2 User Guide - Manual (Page 238)

●
●
●
●
●
FactoryTalk Historian ProcessBook User Guide
220
Configure the Attachments Tab
To configure the Attachments tab:
1. In Build mode, create a connector (page 211). Notice its number in
the tooltip.
2. Create the auxiliary symbol to be added to the Connector.
3. Open the Connectors dialog box (page 216), and select the
Attachments tab.
4. Choose a connector from the numbered list in the drop-down box at
the top.
5. After you select a connector, unattached symbols on the display are
listed in the Symbols box. Symbols that are already attached to the
connector appear in the Currently Attached box. Existing Source and
Destination symbols that are connected to Connectors are not listed.
6. Highlight a symbol in the Symbols box that you want to add and click
Add. The symbol now appears in the Currently Attached box.
7. Adjust the position and placement of the attached symbol as needed.
 To move the symbol closer to one end of the connector, double-
click the specified % and change it.
 To move the symbol from the top of the connector to another
placement, double-click the default Top and choose Left, Right,
or Bottom.
8. Click Apply and select another connector to adjust.
9. If you need to remove an attachment, highlight the attachment in the
Currently Attached box and click Remove.
10. When you are finished adjusting, click OK.