Rockwell Automation FactoryTalk Historian SE ProcessBook 3.2 User Guide - Manual (Page 232)

●
●
●
●
●
FactoryTalk Historian ProcessBook User Guide
214
If a symbol is placed in front of another, the Connection Points on the hidden
symbol cannot be selected. You can solve this problem by placing the two symbols
on different layers of the display.
Add Connection Points
If you want an additional Connection Point, you can add it as follows:
1. In Build mode, select the symbol.
2. Click Edit > Connection Points > Add. A point appears at the upper
left of the symbol.
3. If you wish, drag the new Connection Point to a different location.
Select Among Multiple Connection Points on One
Symbol
After you select one Connection Point, you can press C on the keyboard to
cycle through any additional Connection Points on that symbol.
Delete Connection Points
To delete a Connection Point from a symbol:
1. Select the Connection Point.
2. Click Edit > Connection Points > Delete.
Move Connection Points
Connection Points may be moved to a new position within a symbol. To do
this, click a Connection Point in Build mode and drag it.
For very fine adjustments, you can move Connection Points on a symbol.