Rockwell Automation FactoryTalk Historian SE ProcessBook 3.2 User Guide - Manual (Page 352)

●
●
●
●
●
FactoryTalk Historian ProcessBook User Guide
334
3 = dash dot
4 = dash dot dot
5 = suppress
Font Section
The Font section maps the VAX supported fonts to FactoryTalk Historian
ProcessBook fonts:
StandardFont=35,400,0,0,34,Arial
SmallVector=-29,400,0,0,34,Arial
MediumVector=-52,400,0,0,34,Arial
LargeVector=-77,400,0,0,34,Arial
These default values are based on resolutions for VT340 terminals. If you are
using a terminal other than these, appearances may be different.
The values to the right of the equal sign represent these font characteristics.
Position Font Characteristic Definition
1 Height Specifies the height of the font. If the value is greater
than zero, it specifies the cell height. If the value is less
than zero, it specifies the character height, which is the
cell height minus the leading.
2 Weight Specifies the weight of the font (for example, light,
medium, bold). Values can be from 0 to 900 in increments
of 100. 100 equals the lightest; 900 the darkest.
3 Italic Specifies an italic font if the value is not zero (for
example, 0 = non-italic; 1 = italic).
4 Underline Specifies an underlined font if the value is not zero (for
example, 0 = non-underlined; 1 = underlined).
5 Pitch and Family Specifies the pitch and family of the font. Pitch can be
fixed, variable, or default. Font families, such as Old
English, describe the look of a font in a general way. They
are intended for specifying fonts when the exact typeface
desired is not available.
6 Face Name Specifies the typeface name of the font.