Banner PresencePLUS Pro COLOR—PROII Camera - Manual (Page 29)

Chapter 4 Setup
4.1 Setup Screen
The Vision sensor has two modes: running and idle. If the sensor is idle when you start up the PresencePLUS software
while your PC is connected, the software starts in the Setup screen. If the sensor is running, then the software starts in
the Run screen.
4.2 Capturing a Reference Image
The reference image is used as a template for developing an inspection. The Vision tools use this image to acquire the
critical information needed for the inspection.
Acquiring a quality image is crucial for a successful inspection. A quality image shows a measurable and repeatable
difference between good products (which pass inspection) and bad products (which fail inspection). Most commonly,
what determines the quality of the image is the illumination.
4.3 Focus Tab
The Focus tab on the Setup screen is used to:
•
Reference Image Source
on page 30
•
Focus Value
on page 31
•
Auto Exposure
on page 31
Focus tab
29 Minneapolis, MN USA Banner Engineering Corp.