Banner PresencePLUS Pro COLOR—PROII Camera - Manual (Page 85)

Description Strobe Width Option
The strobe output remains active (light on).
On
The strobe output is active only while the sensor is
acquiring an image. This is the default.
Exposure Duration
Sets the duration for active strobe output from the initial
valid trigger (minimum pulse width has been satisfied) to
the end of the duration. The range is from 0 to 4,000 ms.
Time Duration
6.5.2 Level
• Active Low -- When given a 0V dc signal, it turns on. This is the default.
• Active High -- When given a +5V dc signal, it turns on.
6.6 Trigger Tab
In the Trigger tab, the trigger must be set for current sourcing (NPN) or for current sinking (PNP). Select NPN or PNP .
The default is NPN.
85 Minneapolis, MN USA Banner Engineering Corp.
System Setup Dialog 2/2010