Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 114)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
106 / SYSTEM CONFIGURATION
HOPPER ASSIGNMENT
The Hopper Assignment screen displays:
• Module address
• Type
• Number of hoppers
• Hopper numbers for the system
To Assign Hoppers:
1. At the Module Configuration screen, press the Hopper Assignment
button to access the Hopper Assignment screen.
Figure 65
Hopper Assignment Screen
The following data items can be edited:
IMPORTANT: The # of Hopp data items for each listed module and the
Hopp #’s value automatically populates if Auto Config is
used to configure the installed sensors.
# OF HOPPERS
NOTE: Only modules that support
hopper sensors display on the
Hopper Assignment screen.
The # of Hopp column displays the total number of hopper sensors that are
connected to each module. The HOPP #’s value is automatically configured
for proper numbering sequence for each module based upon the module
address value when an Auto Config is performed.