Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 53)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
SYSTEM CONFIGURATION / 45
MATERIAL SETUP CONSTANTS-LIQUID FLOW
Material Setup for Liquid Flow control.
NOTE: Refer to Control Setup to link a
material to a channel.
Figure 32
Liquid Flow Material Setup Screen
TARGET RATE
Target Rate establishes the desired rate of application in gallons per acre
(Liters/Ha).
MAX RATE
Maximum Rate establishes the maximum application rate in gallons per
acre (Liter/Ha) that the control will allow. Target Rate cannot be
incremented to a value greater than this established maximum rate.
MIN RATE
Minimum Rate establishes the minimum application rate in gallons per acre
(Liter/Ha) that the control will allow. Target Rate cannot be decremented to
a value lower than this established minimum rate.
INC/DEC %
The Increment/Decrement Percent rate establishes the percentage of
change that will be applied each time the Increment/Decrement button is
pressed on the Main Work screen.
IMPORTANT: The maximum or minimum rates may not be reached if
the % increase or decrease, based off the Target Rate,
exceeds the maximum or minimum rate limits set.
EXAMPLE: Maximum Rate is set for 101. Target Rate is set for 100. If the
% increase is set at 2%, the maximum rate of 101 will not be met because
the % increase of 2% would exceed the 101 maximum rate limit.