Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 36)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
28 / SYSTEM MODES
SETUP/CONFIGURATION MODE
When the master switch is in the OFF position, the VT is in Setup/
Configuration mode. In this mode, all control and monitoring functions
cease. A password is required to access this mode.
Figure 20
Setup/Configuration Mode
AVAILABLE BUTTONS IN SETUP MODE
Additional buttons for system configuration and parameter setup functions
are enabled and only appear in setup/configuration mode. Refer to the
System Configuration section for information on these functions.
PLANTER FILL DISK
The Planter Fill Disk button is used to fill the seed meters with seed to allow
instant seed flow when the channel is turned ON. Pressing the Fill Disk
button rotates the seed meters on ALL ACTIVE planter control channels
one revolution, then stops. For additional information, refer to the System
Configuration section.
ROW MONITOR SETUP
The Row Monitor Setup button accesses the Row Monitor Setup screen. All
user-entered constants relating to general planter monitor functions are
accessed on this screen.
CONTROL SETUP
The Control Setup button accesses the Control Setup screen. Up to 16
different materials can be configured and stored for planter, liquid, fertilizer,
RPM control, and monitor only.
Setup
Screen 1
Buttons Setup
Screen 2
Buttons Setup
Screen 3
Buttons