Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 92)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
84 / SYSTEM CONFIGURATION
GEAR RATIO
Gear Ratio specifies the actual ratio from the application rate sensor to the
output shaft. This specifies the number of revolutions the application rate
sensor turns in relation to one revolution the final output shaft turns.
# SEED ROWS
Allows entry of a specific number of seed rows to the control channel. Row
assignment is given a priority based on the channel and will be assigned
sequentially thereafter. Channel 1 will always be assigned to the first set of
rows, Channel 2 the next set of rows, and so on. This will disable the row
alarms when a respective channel is turned off. This entry is only available
for Granular Seed Monitor channel.
CHANNEL WIDTH
Granular Seeding
Channel Width requires a manual entry of the implement width for rows
assigned to a specific channel.
Granular Fertilizer
Channel Width requires a manual entry of the fertilizer spread width.