Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 124)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
116 / SYSTEM CONFIGURATION
Figure 72
Manual Ground Speed
RELUCT FREQ
Used when ground speed is provided by a reluctance (2-wire) type sensor
connected to the actuator harness through an adapter harness.
DIGITAL FREQ
Used when ground speed is provided by a radar/digital (3-wire) type sensor
connected to the actuator harness.
CAN GROUND
Used when ground speed is provided by a radar/digital (3-wire) type sensor
connected to the cab harness or if radar/forward ground speed is
communicated on the CAN bus.
CAN WHEEL
Used when wheel speed data is communicating on the CAN bus. This
source does account for slip-like CAN ground.
NOTE: Manual ground speed can only
be entered if the source is
changed to MANUAL.
GSPD CONSTANT
Ground Speed Constant is the value representing the pulse count produced
by the ground speed sensor over a 400’ distance. Refer to Ground Speed
Calibration for additional information.
SHUT OFF SPEED
Shut Off Speed indicates the minimum ground speed allowed before the
system shuts off all control channels.
MINIMUM OVERRIDE
Minimum Override takes over when actual ground speed is below the
designated value. The control will operate at this speed until actual ground
speed rises above the minimum override speed or the actual speed drops
below the shutoff speed.