Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 34)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
26 / SYSTEM MODES
AVAILABLE BUTTONS IN OPERATE MODE
Virtual buttons on the display are used to interact with the system.
Top-level buttons that appear on the Operate and Setup/Configuration
screens are defined below.
NEXT CHANNEL
The Next Channel button selects the next available channel to be active
and viewable, as illustrated in
Figure 20 , “Channel 1”. The active channel
can be set to ON or OFF by selecting the Turn On/Off Channel button. The
active channel is displayed in reverse video display in a multiple channel
configuration.
The Target Rate can be adjusted by using the Inc/Dec buttons. The Next
Channel button advances to the next available channel information. The
channel’s Inc/Dec buttons, as well as the ON/OFF buttons, display the
current channel label. This key is visible only when multiple channels have
been configured.
NEXT SCREEN
The Next Screen button displays the next configured work screen. The
number to the left of the graphic identifies the current screen. The number
on the right identifies the next screen to display. The Next Work Screen only
displays if multiple screens are configured.
INCREMENT
The Increment button increases the active channel’s target rate by the
amount specified in the Inc/Dec % or rate table setup for that material.
Increment can be pressed several times to increase the target rate by the
specified amount for every actuation, until the maximum rate value or
preset value is reached. The active channel/material is displayed in the
button text.
DECREMENT
The Decrement button decreases the active channel’s target rate by the
amount specified in the Inc/Dec% or rate table setup for that material.
Decrement can be pressed several times to reduce the target rate by the
specified amount for every actuation, until the minimum rate value or preset
value is reached. The active channel/material is displayed in the button text.
INC/DEC RESET TO TARGET
The Inc/Dec Reset to Target button is used to return the active channel to
the original material target rate. This button is only available for channels
that are active and have had the target rate adjusted using the Increment or
Decrement buttons in inc/dec % mode. The active channel displays in the
button text.