Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 140)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
132 / DATA ITEMS
GROUND SPEED
Ground Speed displays the current ground speed of the tractor in miles per
hour (Kph). The ground speed source is defined during the Ground Speed
Calibration setup. This data item also displays the implement status using
an up/down arrow next to the tractor icon.
TOTAL AREA
NOTE: Data Items on the Main Work
screen with a check box allows
the number to be reset to zero.
Total Area displays the area covered by the implement in acres (Ha). Total
area is calculated using the Implement Width parameter entered on the
Row Status/Row Width Setup screen. Area accumulates for seeding
when seeds are detected on at least one seeding row and the ground
speed is above the Shutoff Speed parameter entered on the Ground
Speed Calibration screen. This accumulator is independent of any other
area accumulator and can be reset to 0.0 at any time. Current area is
retained after power down. If no rows are configured, the Total Area
Accumulator will use the largest channel width.
NOTE: All Data Items are selected
from the Work Configuration
screen. Refer to the Work
Screen Configuration section
for setup instructions.
FIELD 1 AREA
Field 1 Area displays the area covered by the implement in acres (Ha). Field
1 Area is calculated in the same manner as Total Area. This accumulator is
independent of any other area accumulator and can be reset to 0.0 at any
time. Current area is retained after power down.
FIELD 2 AREA
Field 2 Area displays the area covered by the implement in acres (Ha). Field
2 Area is calculated in the same manner as Total Area. This accumulator is
independent of any other area accumulator and can be reset to 0.0 at any
time. Current area is retained after power down.
7 . 7
MPH
0 . 0 0
AC T
Reset
0 . 0 0
AC T
Reset box
0 . 0 0
AC 1
Reset
0 . 0 0 AC 2
Reset