Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 62)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
54 / SYSTEM CONFIGURATION
MATERIAL SETUP CONSTANTS - SPLIT AIR
REGULATION
The following constants on the Material Configuration Setup screen define
the parameters for Split Air Regulation control.
Figure 37
Split Air Regulation
TARGET RATE
Target Rate establishes the desired rate of application in inches of H 2 0.
MAX RATE
Maximum Rate establishes the maximum application rate in inches of H 2 0.
Target Rate cannot be incremented to a value greater than this established
maximum rate.
MIN RATE
Minimum Rate establishes the minimum application rate in inches of H
2
0.
Target Rate cannot be decremented to a value lower than this established
minimum rate.
INC/DEC %
The Increment/Decrement percent rate establishes the percentage of
change of the entered target rate that will be applied each time the
Increment/Decrement button is pressed on the Main Work screen.
IMPORTANT: The Maximum or Minimum Rates may not be reached is
the % increase or decrease, based off the Target Rate,
exceeds the maximum or minimum rate limits set.