Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 25)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
INSTALLATION / 17
NOTE: The ignition lead must be
connected to switched +12VDC
for the system to power up and
down properly.
5” VIRTUAL TERMINAL CAB HARNESS CONNECTIONS
1. Connect the power leads directly to the battery.
2. Connect the ignition wire to a switched +12VDC.
3. Connect the Chassis Ground lead to a bare point of the cab frame that
offers a good chassis ground connection.
4. Connect the Master Switch, CAN Terminator and Radar Speed Sensor
to their respective connectors on the cab harness. If the Speed Sensor
is to be connected to the WSMT, do not connect anything to the Speed
Sensor connector on the Cab Harness.