Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 128)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
120 / SYSTEM CONFIGURATION
5” VT AUX INPUT/FUNCTION ASSIGNMENT
The Auxiliary Input/Function Setup screen configures the location of the
system’s master switch. For proper assignment, the master switch must be
configured correctly.
An installed master switch located in the tractor cab is the preferred method
for auxiliary input; however a Master Switch button on the Virtual Terminal
is available if there is no master switch installed in the cab.
On initial powerup, a Master Switch Assignment alarm activates requiring
action
( Figure 76 ).
• Press either the Master Switch button or
• Press the No Master Switch button
Figure 76
Master Switch Assignment Alarm
IMPORTANT: If the master switch is not configured, the master switch
Assignment Alarm will activate at each power cycle until
an auxiliary assignment is made and will default to the
master switch button to activate auxiliary inputs.
MASTER SWITCH ASSIGNED
If assigning a master switch, the Virtual Terminal must be configured to
acknowledge the assignment.
To Configure an installed master switch:
1. Press the ESC key 2 times to activate the Virtual Terminal Setup
screen.
2. Press the Auxiliary Input/Function Setup button to access the
Auxiliary Input/ Function Setup screen ( Figure 77 ).
ESC
Aux
Master Switch
Assignment
Alarm
!
Master
Switch
No
Master
Switch
Master switch assignment is invalid
If physical auxiliary switch is available
Press softkey #1 to accept physical
auxiliary switch available and then
correct the assignment.
If no physical auxiliary switch is
available
Press softkey #2 to accept NO
physical auxiliary switch available