Operator’s manual – Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 User Manual
Page 72
Advertising
OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
64 / SYSTEM CONFIGURATION
TEST SEED COUNT
NOTE: The Test Seed Count will
automatically reset whenever a
new Continuous Test is
performed.
Test Seed Count is the seed count reported back on the specified row set in
the row data item and is automatically populated.
To start the Continuous Test:
1. Press the Start button.
2. Press and hold remote test switch until the test is complete.
3. Release test switch and the control will stop.
4. Press the test switch again to clear the seed count and restart the
control.
5. Steps 2-4 will repeat until the Stop button is pressed.
STOP
Advertising
This manual is related to the following products: