Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 30)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
22 / INSTALLATION
1. Connect the Implement CAN Breakaway extension to the mating
connector of the Cab Harness. Route the harness along the implement
hitch to the WSMT module harness (use an Implement Extension
Harness if additional length is needed). Secure harness as needed.
2. Connect the Module Harness to the mating connectors of the
Implement CAN harness, and then connect the module to the harness.
The WSMT module uses a 30 and 18 way connector with a jackscrew
to secure the connector to the module. The WSMB uses a pair of
12-pin connectors. Secure module harness as needed.
SENSOR INSTALLATION
For proper system operation, all sensors used with the system must be
connected properly as described in the following sections. Sensors that are
incorrectly installed will not be properly identified by the system and will
result in incorrect numbering of the sensors.
SEED SENSORS
The system is compatible with all existing DICKEY-john seed sensors.
Seed sensors may be connected to the WSMT module and all WSMB
Planter Monitor Modules. Any number of sensors up to the maximum
capacity of the module may be connected. A maximum of 214 seed sensors
can be connected to the system.