Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 45)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
SYSTEM CONFIGURATION / 37
Figure 26
Material Setup Screen-Preset Method Enabled
PRESET METHOD DISABLED
When the Preset Method is disabled, the target rate on the Main Work
screen can be adjusted by pressing the Material Increment/Decrement
buttons. The target rate will increase or decrease based on the Inc/Dec %
value set at the Material Setup screen.
NOTE: Rate changes can only occur
on actively viewed control
channels.
Figure 27
Material Configuration Setup Screen-Preset Method Disabled
185
With Preset enabled, target
rate adjusts based on the
rates entered at the Material
Setup screen.
With Preset disabled,
target rate adjusts
based on the Inc/Dec %
rate set at the
Material Setup screen.
Value left of target
symbol is the difference
off of target rate.