Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 148)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
140 / SYSTEM OPERATION
OPERATE SCREEN SYMBOLS
TARGET RATE
The Target Application Rate displays when Master Switch is off. The actual
applied rate appears during Operate mode.
INCREASE/DECREASE % RATE
The Increase/Decrease rate is the percentage change being applied each
time the Material Increase/Decrease button is pressed during Operate
mode.
TARGET PRESET RATE
The Preset Rate is the applied rate that was entered at the Material
Configuration setup screen and increases or decreases when the Material
Increase/Decrease button is pressed during Operate mode.
IMPLEMENT LIFT SWITCH
When an implement lift switch is installed, the Main Work screen will identify
if the implement is in the up or down position. Using an implement lift switch
automatically turns the control channels on and off without turning the
master switch off. The Implement Lift Indicator must be in the Down position
for the control channels to operate. The Implement Lift Switch box on the
Ground Speed Configuration screen must be enabled if an implement
lift switch is used.
Refer to the Implement Lift Sensor instructions for installation location.
TASK CONTROLLER
The Task Controller icon appears on the Main Work screen when Task
Controller is active and controlling the application rate. Return to Task
Controller to stop a task.
ROW INDICATORS
Row Indicators in bar graph format on the bottom of the Work screen
indicate seed rate for each row. The size of the bar graphic is set on the
Work Configuration screen by pressing the Work Screen button.
+
RATE 1
Implement Lift
Indicator
(Down Position-GREEN)
Implement Lift
Indicator
(Up Position-RED)
T C T C
Setting Task
Controller Rate Logging Data
to SD card
T C
Setting Task
and Logging
Data