Status table – KEYENCE IV Series User Manual
Page 259
A-3
- IV Series User's Manual (Monitor) -
A
Status Table
Status table
Status
Monitor
screen
type
Sensor operation indicator light
Input
Output
PWR/ERR
OUT
TRIG
External
trigger
Switch
programs
External
master image
registration
Clear
Error
BUSY
Total Status / Total status NG /
Each tool / Each logic /
Pos.Adj.
*1
RUN
Error
Running
*2
Waiting for a trigger
RUN
Lighting
(green)
*3
OFF
¡
¡
¡
Í
OFF
*4
ON
OFF
Judgment processing
*5
*6
*7
*8
ON
Switching programs
*9
OFF
*10
*11
*12
Registering the external master image
*11
*10
Setting
Limit Adjustment
TEST
Blink
(green)
OFF
*5
¡
Н
Н
Н
Same
as while
running
OFF
OFF
OFF
Trigger Options, Master Registration, etc.
LIVE
Focus adjustment (MF)
OFF
*14
OFF
Automatically adjusting the brightness
Automatically adjusting the focus (AF)
Blink
(green)
OFF
*13
Í
*13
Setup Adjustment
-
*15
OFF
I/O Monitor
OFF
*16
←
←
←
←
←
←
Others
Н
Н
Н
Н
OFF
OFF
OFF
Error
Trigger error
Running
RUN
Blink (red)
Same as normal
Same as normal
¡
Same as normal
ON
Setting
LIVE
External master registration error
-
System error
Lighting
(red)
OFF
OFF
Н
Н
Н
Н
OFF
OFF
OFF
Startup memory readout error
*17
*17
*17
*6 Disregards the input. A trigger error occurs.
*7 Stops the judgment process and switches over.
*8 Stops the judgment process and registers the previously taken image as a master image.
*9 Turns off the light before the process is completed. Until the light turns off, the previous status result
will be displayed.
*10 After the current process is completed, generates the new input.
*11 Do not use. The processing order becomes indeterminate.
*12 Turns OFF before the process is completed. Outputs the previous status result until this turns OFF.
*13 The internal trigger is issued automatically and the image will be updated. The Busy output operates.
*14 The flashing cycle of the orange light changes by linking to the focus indicator. The STATUS indicator
light operates in the same way.
*15 The internal trigger is issued automatically and the image is updated.
*16 While the I/O monitor function is used, only the operation of the I/O lines is confirmed. The assigned
functions will not operate.
*17 The NPN open collector output turns OFF regardless of the output settings (N.O./N.C.) and the
polarity (NPN/PNP) settings.
Additionally, refer to “Chapter 7 Controlling with Input/Output Line” (Page 7-1).