Basler Electric DGC-2020 - Manual (Page 127)

L Application Version: Read-only value obtained when BESTCOMSPlus is communicating with an
optional LSM-2020.
M Boot Code Version: Read-only value obtained when BESTCOMSPlus is communicating with an
optional LSM-2020.
N Application Build Date: Read-only value obtained when BESTCOMSPlus is communicating with an
optional LSM-2020.
O Serial Number: Read-only value obtained when BESTCOMSPlus is communicating with an optional
LSM-2020.
P Application Part Number: Read-only value obtained when BESTCOMSPlus is communicating with an
optional LSM-2020.
Q Model Number: Read-only value obtained when BESTCOMSPlus is communicating with an optional
LSM-2020.
R Application Version: Read-only value obtained when BESTCOMSPlus is communicating with an
optional CEM-2020.
S Boot Code Version: Read-only value obtained when BESTCOMSPlus is communicating with an
optional CEM-2020.
T Application Build Date: Read-only value obtained when BESTCOMSPlus is communicating with an
optional CEM-2020.
U Serial Number: Read-only value obtained when BESTCOMSPlus is communicating with an optional
CEM-2020.
V Application Part Number: Read-only value obtained when BESTCOMSPlus is communicating with an
optional CEM-2020.
W Model Number: Read-only value obtained when BESTCOMSPlus is communicating with an optional
CEM-2020.
X Application Version: Read-only value obtained when BESTCOMSPlus is communicating with an
optional AEM-2020.
Y Boot Code Version: Read-only value obtained when BESTCOMSPlus is communicating with an
optional AEM-2020.
Z Application Build Date: Read-only value obtained when BESTCOMSPlus is communicating with an
optional AEM-2020.
AA Serial Number: Read-only value obtained when BESTCOMSPlus is communicating with an optional
AEM-2020.
BB Application Part Number: Read-only value obtained when BESTCOMSPlus is communicating with an
optional AEM-2020.
CC Model Number: Read-only value obtained when BESTCOMSPlus is communicating with an optional
AEM-2020.
Device Security Setup
Password protection guards against unauthorized changing of DGC-2020 settings. DGC-2020 passwords
are case sensitive. Three levels of password protection are available. Each level is described in the
following paragraphs.
•
OEM Access. This password level allows access to all settings. The default, OEM-access password
is OEM.
•
Settings Access. This password level allows all except uploading of firmware and clearing of device
event log. The default, settings-access password is SET.
•
Operator Access. The default, operator-access password is OP. This password level allows all
settings to be read and allows changes to be made to the following:
o LCD Contrast
o Sleep Mode
o Date/Time
o All Sender Fail Time Delays
o Metric Conversion
o Low Fuel Pre-Alarm Level
o Low Fuel Alarm Level
o Pre-Start Contact after Cranking
o Cooldown Time
o Pre-Crank Time Delay
9400200990 Rev X DGC-2020 BESTCOMSPlus
® Software
4-17