Basler Electric DGC-2020 - Manual (Page 50)

○ BOOST PRESS
○ INTAK MNFLD TEMP
○ AIR FLTR DIF PRS
○ EXHAUST GAS TEMP
○ BATTERY VOLTAGE
○ ECU INPUT VOLTS
○ TRANS OIL PRESS
○ TRANS OIL TEMP
○ WINDG 1 TEMP
○ WINDG 2 TEMP
○ WINDG 3 TEMP
○ ECU TEMP
○ AUX PRESSURE1
○ AUX PRESSURE2
○ RATED KW
○ RATED RPM
○ EXHAUST TMP A
○ EXHAUST TMP B
○ CHRG AIR TMP
○ FUEL 1 LEAK
○ FUEL 2 LEAK
○ ALARM RST FDBK
○ ECU SHUTDOWN
○ DEF TANK 1 LVL %
○ DEF TANK 2 LVL %
● J1939 ENGINE CONFIG (Visible when ECU is configured for Standard, Volvo Penta, MTU ADEC, GM/Doosan,
or Cummins.)
○ SPD @ IDLE PNT 1
○ TRQ @ IDLE PNT 1
○ SPD @ PNT 2
○ TRQ @ PNT 2
○ SPD @ PNT 3
○ TRQ @ PNT 3
○ SPD @ PNT 4
○ TRQ @ PNT 4
○ SPD @ PNT 5
○ TRQ @ PNT 5
○ SPD @ PNT 6
○ ENDSPEED GOV KP
○ REF ENG TORQUE
○ O-RIDE SPD PNT 7
○ O-RIDE TIME LMT
○ SPEED LOWER LMT
○ SPEED UPPER LMT
○ TORQUE LOWER LMT
○ TORQUE UPPER LMT
● J1939 ACTIVE DTC (Visible when DTC support is enabled and any ECU type is selected.)
○ CLEAR DTCs
● J1939 PREV DTC (Visible when DTC support is enabled and any ECU type is selected.)
○ CLEAR DTCs
● NETWORK STATUS (Visible when Multiple Generator is selected as System Type.)
○ SYSTEM MANAGER (Displays “0” when LSM-2020 is not connected.)
○ NUMBER OF UNITS (Displays “0” when LSM-2020 is not connected.)
○ ID (Visible when LSM-2020 is connected.)
○ NUM ON LINE (Displays “0” when LSM-2020 is not connected.)
○ ID X (X = 1 to 16) (The ID of each online unit is displayed)
○ SYS KW CAP
○ SYS GEN KW
○ SYS GEN KVAR
● SEQUENCING STATUS (Visible when Demand Start/Stop is enabled.)
○ NEXT TO START (Displays “0” when LSM-2020 is not connected.)
○ NEXT TO STOP (Displays “0” when LSM-2020 is not connected.)
○ START TMR 1
○ START TMR 2
○ STOP TIMER
○ WATT DEMAND
○ MODE
2-10 DGC-2020 Human-Machine Interface 9400200990 Rev X