Basler Electric DGC-2020 - Manual (Page 6)

Manual
Revision and Date
Change
P, 08/11 •
Revised to support firmware package version 1.13.04 (see firmware
package version history) and BESTCOMSPlus version 2.10.02 (see
BESTCOMSPlus version history).
•
Added LCD Heater specifications in Section 1.
•
Added Analog Input Burden data in Section 10.
•
Updated Activation of DGC-2020 Plugin for BESTCOMSPlus and
Communication in Section 4.
•
Improved Figure 8-9, Typical LSM-2020 Interconnection Diagram.
O
•
This revision letter not used.
N, 04/10
•
Revised to support firmware package version 1.10.00 (see firmware
package version history) and BESTCOMSPlus version 2.07.01 (see
BESTCOMSPlus version history).
•
Changed Battery Backup for Real-Time Clock to a standard feature.
•
Added Table 3-3, J1939 Data Transmitted from the DGC-2020.
•
Added Table 4-2, Generator Parameter Transmit.
M, 11/09 •
Section 1: Under Specifications, Metering, Power Factor, changed
calculation method from “PF = P (3-phase average) / S (3-phase
average)” to “PF = Cosine of the Angle between Phase AB voltage
(Vab) and Phase A current (Ia)”.
•
Added “Diagnostics” to Figure 2-2, Metering Screen Branches.
•
Section 3: Updated MTU Fault Code list.
•
Added description for Logic Control Relays in Table 5-1.
•
Updated cutout dimensions in Figure 6-1, Panel Cutting and Drilling
Dimensions.
•
Section 6: Added Setting Up DGC-2020 Programmable Inputs and
Outputs, Synchronizer, and Setting up a DGC-2020 and LSM-2020 for
a Load Sharing and kW Control Application.
•
Section 10: Added Maximum Consumption under Specifications,
Operating Power.
•
Appendix B: Improved description for registers 40020, 43750, and
45754.
iv DGC-2020 Introduction 9400200990 Rev X