Basler Electric DGC-2020 - Manual (Page 58)

● ANALOG OUTPUTS (Visible when AEM-2020 is enabled.)
○ ANALOG OUTPUT X (X = 1 to 4)
■ OUTPUT TYPE
■ MIN VOLTAGE
■ MAX VOLTAGE
■ MIN CURRENT
■ MAX CURRENT
■ PARAM MIN
■ PARAM MAX
■ OOR ALM CFG
■ OOR ACT DLY
■ PARAM
CONFIG PROTECTION
● SCALE FACTORS
○ ALT FREQ SF
○ VOLT LO LINE SF
○ AMPS LO LINE SF
● CONFIG PROT X (X = 1 to 9)
○ PARAM
○ OVER 1
■ THRESHOLD
■ ALARM CONFIG
○ OVER 2
■ THRESHOLD
■ ALARM CONFIG
○ UNDER 1
■ THRESHOLD
■ ALARM CONFIG
○ UNDER 2
■ THRESHOLD
■ ALARM CONFIG
○ ARMING DELAY
○ THR1 ACT DLY
○ THR2 ACT DLY
○ HYSTERESIS
○ NAME
ALARM CONFIGURATION
● HORN CONFIGURATION
○ HORN
○ NOT IN AUTO HORN
● PRE-ALARMS
○ HIGH COOLANT TEMP
■ ENABLE
■ THRESHOLD
○ LOW COOLANT TEMP
■ ENABLE
■ THRESHOLD
○ LOW OIL PRESSURE
■ ENABLE
■ THRESHOLD
○ LOW FUEL LEVEL
■ ENABLE
■ THRESHOLD
○ ENGINE OVERLOAD
■ ENG kW OVRLD-X (X = 1 to 3)
□ ENABLE
□ LOW LINE SF (Visible when an input is selected for the Low Line Override
programmable function.)
□ 3 PHASE SETTINGS
♦ THRESHOLD
♦ HYSTERESIS
2-18 DGC-2020 Human-Machine Interface 9400200990 Rev X