Basler Electric DGC-2020 - Manual (Page 59)

□ 1 PHASE SETTINGS
♦ THRESHOLD
♦ HYSTERESIS
○ MAINTENANCE INTERVAL
■ ENABLE
■ THRESHOLD
○ BATTERY OVERVOLTAGE
■ ENABLE
■ THRESHOLD
○ LOW BATTERY VOLTAGE
■ ENABLE
■ THRESHOLD
■ ACTIVATN DLY
○ WEAK BATTERY VOLTAGE
■ ENABLE
■ THRESHOLD
■ ACTIVATN DLY
○ HIGH FUEL LEVEL
■ ENABLE
■ THRESHOLD
■ ACTIVATN DLY
○ ACTIVE DTC (Visible when DTC is enabled.)
■ ENABLE
○ ECU COMMS FAIL (Visible when CAN bus is enabled.)
■ ENABLE
○ COOLANT LEVEL (Visible when CAN bus is enabled.)
■ ENABLE
■ THRESHOLD
○ AVR OUTPUT LIMIT (Visible when LSM-2020 is enabled.)
■ ENABLE
■ ACTIVATN DLY
○ GOV OUTPUT LIMIT (Visible when LSM-2020 is enabled.)
■ ENABLE
■ ACTIVATN DLY
○ INTERGENSET COMM FAIL (Visible when LSM-2020 is enabled.)
■ ENABLE
○ LSM COMM FAIL (Visible when LSM-2020 is enabled.)
■ ENABLE
○ CEM COMM FAIL (Visible when CEM-2020 is enabled.)
■ ENABLE
○ AEM COMM FAIL (Visible when AEM-2020 is enabled.)
■ ENABLE
○ ID MISSING (Visible when LSM-2020 is enabled.)
■ ENABLE
○ ID REPEAT (Visible when LSM-2020 is enabled.)
■ ENABLE
○ CHECKSUM FAIL
■ ENABLE
○ SYNC FAIL PALM
■ ENABLE
○ BRK CLOSE FAIL PALM
■ ENABLE
■ MONITOR
○ BRK OPEN FAIL PALM
■ ENABLE
■ MONITOR
○ REVERSE ROTATION
■ ENABLE
•
ALARMS
○ HIGH COOLANT TEMP
■ ENABLE
■ THRESHOLD
■ ARMING DELAY
○ LOW OIL PRESSURE
■ ENABLE
■ THRESHOLD
■ ARMING DELAY
9400200990 Rev X DGC-2020 Human-Machine Interface 2-19