Cloud Electronics DCM1 - Manual (Page 4)

DCM1 & DCM1e Installation and User Guide v1.0 4
Safety Information
Safety Notes regarding Installation
•
Do not expose the unit to water or moisture.
•
Do not expose the unit to naked flames.
•
Do not block or restrict any air vent.
•
Do not operate the unit in ambient temperatures above
35°C.
•
Do not perform any internal adjustments unless you
are qualified to do so and fully understand the hazards
associated with mains-operated equipment.
•
The unit has no user-serviceable parts. Refer servicing
to qualified service personnel.
•
If the moulded plug is cut off the mains lead for any
reason, the discarded plug is a potential hazard and
should be disposed of in a responsible manner.
Conformities
This product conforms to the following European EMC
Standards:
BS EN 55103-1:2009
BS EN 55103-2:2009
This product has been tested for use in commercial and
light industrial environments. If the unit is used in controlled
EMC environments, the urban outdoors, heavy industrial
environments or close to railways, transmitters, overhead
power lines, etc., the performance of the unit may be degraded.
The product conforms to the following European electrical
safety standard:
BS EN 60065:2002 (+A2:2010)
Safety Considerations and
Information
The DCM1 and DCM1e are powered by separate Power
Supply Units (PSUs), which must be earthed. Ensure that the
mains power supply provides an effective earth connection
using a three-wire termination.
Mains Fuse
The PSU is a sealed unit and contains no user-replaceable
fuses. Mains over-current protection is provided by the fuse
in the 13 A plug, which should be rated at 5 A.
Caution – Servicing
The unit contains no user-serviceable parts. Refer servicing to
qualified personnel. Do not perform servicing unless you are
qualified to do so. Disconnect the power supply from the unit
before removing the top panel and do not make any internal
adjustments with the unit switched on. Only reassemble the
unit using bolts/screws identical to the original parts.