Cloud Electronics DCM1 - Manual (Page 54)

DCM1 & DCM1e Installation and User Guide v1.0 54
The default state is for all Groups to be unassigned and
disabled. To assign a Zone to the selected Group, tap/click on
the red cross; it will turn into a green tick. Similarly, to enable
the Group, tap/click on the red cross against the Group name.
The functions on this page correspond to the menu functions
Group Enable and Define Groups respectively. See page
29 and page 46 for full details.
Inputs
This menu allows definition of which Line Inputs are available
to each Zone and/or Group, and enabling/disabling of Mic
Inputs.
Select Inputs and then the Zone to be configured (Zone
1
to Zone 8). If any Groups have been defined and enabled,
the Zones comprising a Group will not be listed individually,
but the enabled Group will be added to the list. The display
changes to the Zone n (or Group n) Page:
To make a Line Input unavailable to the selected Zone/Group,
tap/click the green tick against its name; it will turn into a red
cross. The default state is for all Line Inputs to be available
to every Zone and Group. This function corresponds to the
menu function Input Enable; see page 33 for full details.
To activate a Mic Input for the selected Zone/Group, tap/
click the red cross against its name. The default state is for all
Mic Inputs to be Off in all Zones and Groups. This function
corresponds to the menu function Enable Mic Inputs; see page
32 for full details.
Config
This menu has eight options, allowing access to various
DCM1e System and other configuration functions.
Security Page:
Tap/click Security to open the Security Settings
Page.
This function is specific to the browser and gives the installer
much greater control over how the DCM1e is configured in
terms of who has access to which controls than is possible
from the DCM1e itself. As described elsewhere in this manual,
the standard hardware security settings provide two Modes:
User and Installer.
•
User Mode allows immediate control of music level,
music source selection and enabling/disabling of any
Groups which have been defined.
•
Installer Mode allows access to all other menu functions.
The DCM1e browser interface allows for a third,
“intermediate” level of operator – “Power”. The DCM1e’s
functions are presented as a set of categories, and the
installer can assign an access level – User, Power or Installer
– independently to each category. This gives the facility in
which the DCM1e is installed improved control over which
staff members can access which audio and system functions.