Hypertherm HSD130 HySpeed Plasma - Manual (Page 109)

INSTALLATION
HySpeed HSD130 RHF Instruction Manual 3-41
Fill the power supply with coolant
The system will take 11.4 – 15.1 liters (3 to 4 gallons) of coolant depending on the length of the torch leads and
whether the system has a local or remote ignition console.
3. The level of coolant in the tank will have dropped. Add coolant until the tank is full and replace the filler cap.
1. Add coolant until the tank is full.
2. Press and hold the Amps knob on the power supply control panel and turn ON the power to the power supply. This
allows the user to override the 5-second pump time-out and fill the torch leads with coolant for the first time.
Release the amps knob after 60 seconds. If the coolant flow switch is satisfied, the pump will continue to run and
you are done. If the pump turns off, turn OFF the power to the power supply and repeat the process.
Power switch Amps knob