Hypertherm HSD130 HySpeed Plasma - Manual (Page 123)

OPERATION
HySpeed HSD130 RHF Instruction Manual 4-9
Cut charts
The following Cut charts show the consumable parts, cutting speed, and the gas and torch settings required for each
process.
The numbers shown in the Cut charts are recommended to provide high-quality cuts with minimal dross. Because of
differences between installations and material composition, adjustments may be required to obtain desired results.
Material thickness (inches)
Mild steel 0.06 0.135 0.25 0.375 0.5 0.75 1
130 O2/Air 0.061 0.07 0.078 0.088 0.092 0.121
130 Air/Air 0.053 0.062 0.074 0.082 0.107 0.128
50 O2/Air 0.041 0.046 0.058
45 Air/Air 0.032 0.050 0.056
Stainless steel
130 Air/Air
0.065 0.076 0.084 0.109
130 N2/N2 0.065 0.065 0.100 0.139
130 H35/N2 0.113 0.109 0.102 0.116
45 Air/Air 0.032 0.044 0.050
45 N2/N2 0.021 0.026 0.026
45 F5/N2 0.024 0.025 0.032
Aluminum
130 Air/Air
0.082 0.076 0.085 0.106 0.111
130 H35/N2 0.088 0.086 0.079 0.046
45 Air/Air 0.046 0.047 0.048
Estimated kerf width compensation
Material thickness (mm)
Mild steel 1.524 3.429 6.350 9.525 12.70 19.05 25.40
130 O2/Air 1.549 1.778 1.981 2.235 2.336 3.073
130 Air/Air 1.346 1.574 1.879 2.082 2.717 3.251
50 O2/Air 1.041 1.168 1.473
45 Air/Air 0.812 1.270 1.422
Stainless steel
130 Air/Air
1.651 1.930 2.133 2.768
130 N2/N2 1.651 1.651 2.540 3.530
130 H35/N2 2.870 2.768 2.590 2.946
45 Air/Air 0.812 1.117 1.270
45 N2/N2 0.533 0.660 0.660
45 F5/N2 0.609 0.635 0.812
Aluminum
130 Air/Air
2.082 1.930 2.159 2.692 2.819
130 H35/N2 2.235 2.184 2.006 1.168
45 Air/Air 1.168 1.193 1.219