Hypertherm HSD130 HySpeed Plasma - Manual (Page 141)

OPERATION
HySpeed HSD130 RHF Instruction Manual 4-27
Replace torch water tube
Turn OFF all power to the system.
Remove consumables from torch. See Remove consumables in this section.
Remove water tube Install new water tube Replace consumables.
See Install consumables
in this section.
Note: The water tube may seem loose when correctly inserted, but any side-to-side looseness will disappear
after the electrode is installed.
WARNING
Always disconnect power to the power supply before inspecting or changing torch consumable parts.
Coolant will flow from the torch if there is power to the system.
Use gloves when removing consumables. The torch might be hot.