Hypertherm HSD130 HySpeed Plasma - Manual (Page 169)

MAINTENANCE
HySpeed HSD130 RHF Instruction Manual 5-23
Air filter element replacement
A
B
C
1. Disconnect the electrical power and the gas supply.
Remove the filter bowl and the old filter element.
a. Pull down and hold the black release tab. (If you do not see the tab,
check the back of the filter bowl.)
b. Rotate the filter bowl in either direction until it releases.
c. Pull the filter bowl down to remove it. The bowl has an o-ring
around the top. Do not discard the o-ring. If the o-ring needs to be
replaced, use part number 011105.
A
B
C
Re-install the filter bowl.
a. Hold down the black tab and slide the filter bowl over
the new filter element.
b. Align the marks on filter bowl and the filter body.
c. Rotate the filter bowl until it locks in place.
Use a screwdriver to remove the filter element from the filter
housing. Then install the new filter element.
Note: Do not allow the filter element to turn when loosening the
screw.