Common cutting faults -12, Error codes -6, Error codes – Hypertherm HSD130 HySpeed Plasma User Manual
Page 152
Advertising
MAINTENANCE
5-6
HySpeed HSD130 RHF
Instruction Manual
Error codes
Set the selection switch on the power supply to ERROR. The power supply states are shown in the 3-digit LED display
on the power supply. The state ID numbers are 2 digits with a dash in front of them and error codes have 3 digits. When
the selection switch is set to ERROR, the state ID number will be displayed for 2 seconds. An error code number will
then be displayed for 2 seconds. The display will continue to cycle through both numbers until the selection switch is
moved.
3-digit display
Advertising