Hypertherm HSD130 HySpeed Plasma - Manual (Page 137)

OPERATION
HySpeed HSD130 RHF Instruction Manual 4-23
Changing consumable parts
Remove consumables
Check the consumable parts daily for wear before cutting. Before removing consumables, bring the torch to the edge of
the cutting table, with the torch lifter raised to its highest point to prevent the consumables from dropping into the water
of the water table.
Turn OFF all power to the system.
Remove the retaining
cap and shield Remove the nozzle
and swirl ring Remove the
electrode Remove the
swirl ring
Tool part number
027102
WARNING
Always disconnect power to the power supply before inspecting or changing torch consumable parts.
Coolant will flow from the torch if there is power to the system.
Use gloves when removing consumables. The torch might be hot.