Placement of the power supply -15, Connect the torch to the torch lead assembly -29 – Hypertherm HSD130 HySpeed Plasma User Manual
Page 97
Advertising
INSTALLATION
HySpeed HSD130 RHF
Instruction Manual
3-29
Connect the torch to the torch lead assembly
1. Route the leads through the cable track on the table. Leave 2 meters (6.5 ft.) of the leads loose at the torch end to
install the torch.
2. Hold the torch in place and remove the mounting sleeve from the torch assembly.
3. Push back the braided cover and slide the sleeve back over the leads. Align the torch connections with the hoses in
the lead assembly. The hoses must not twist, and they are taped together to help prevent twisting.
4. Connect the coolant hoses to the torch. Red connects to red. Use 2 wrenches to tighten gas and coolant fittings.
Braided cover
Sleeve
Advertising