NavCom StarUtil-3000 Rev.A - Manual (Page 50)

StarUtil-3000 User Guide – Rev A
6. Ensure that Restart receiver after loading (default) is checked so that the receiver will reset
(perform a warm start) after the upload is successful. (The user receives no indication of the
warm start. It is a background process.)
7. Click the Start Loading button. An upload progress window opens. At the end of upload, a
confirmation box opens. Click OK.
Ensure that the receiver has restarted from the warm start before performing the
next step. Monitor the PVT tab/Navigation Status window for a change from “Nav
invalid” to “Nav valid”. Or monitor the LEDs on the front indicator panel of the
receiver. Refer to the SF-3050 GNSS Products User Guide for details on LED
indications (see Related Documents in the fore-matter).
8. Type [GEOIDALMODEL]GEOIDAL99 in Input Terminal and click the Send button (see
Figure 65).
Figure 65: [GEOIDALMODEL] GEOIDAL99 Command and Response
9. View the PVT window on either the Dashboard or the PVT tab to confirm the successful
upload. GEOID99 is identified as the current GEOID (see Figure 56).
The Geoid Height Map (GEOID99) is not maintained as the Geoid Model through
a receiver power cycle in version 1.0.0.4 navigation firmware. This is corrected in
later versions of firmware. To reset the Geoid Height Map as the Geoid Model,
reload the appropriate user profile or input [GEOIDALMODEL]GEOIDAL99 via
the Input Terminal.
4-48