HEIDENHAIN TNC 640 (34059x-05) - Manual (Page 497)

Tools in turning mode (Option #50) 14.4
14
TNC 640 | User's Manual
HEIDENHAIN Conversational Programming | 1/2015
497
14.4 Tools in turning mode (Option #50)
Tool call
Just as in Milling mode, turning tools are called with the
TOOL
CALL function. You merely have to enter the tool number or tool
name in the
TOOL CALL block.
You can call and insert a turning tool both in Milling
mode and in Turning mode.
Tool selection in the pop-up window
If you open a pop-up window for tool selection, the TNC marks all
tools available in the tool magazine green.
In addition to the tool number and tool name, the control also
shows the
ZL and XL columns from the turning tool table.
NC syntax
1 FUNCTION MODE TURN Turning mode selection
2TOOL CALL "TRN_ROUGH" Tool call
...