HEIDENHAIN TNC 640 (34059x-05) - Manual (Page 545)

Using 3-D touch probes 15.7
15
TNC 640 | User's Manual
HEIDENHAIN Conversational Programming | 1/2015
545
15.7 Using 3-D touch probes
Overview
The following touch probe cycles are available in the
Manual
Operation mode:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe. Refer to
your machine manual.
Soft key Function Page
Calibrating the 3-D Touch Probe 553
Measuring a 3-D basic rotation by
probing a plane 561
Measuring a basic rotation using
a line 560
Setting a datum in any axis 563
Setting a corner as datum 564
Setting a circle center as datum 565
Setting the centerline as datum 567
Touch probe system data
management See User’s
Manual for
Cycles