HEIDENHAIN TNC 640 (34059x-05) - Manual (Page 65)

Setting up tools 1.5
1
TNC 640 | User's Manual
HEIDENHAIN Conversational Programming | 1/2015
65
1.5 Setting up tools
Selecting the correct operating mode
Tools are set up in the
Manual Operation mode:
Press the operating-mode key: The TNC switches
to the
Manual mode of operation
Further information on this topic
Operating modes of the TNC: see "Modes of Operation",
page 75
Preparing and measuring tools
Clamp the required tools in their tool holders
When measuring with an external tool presetter: Measure the
tools, note down the length and radius, or transfer them directly
to the machine through a transfer program
When measuring on the machine: store the tools in the tool
changer, see page 67