Tyco F3200 - Manual (Page 145)

Document No: LT0122 F3200 Installation & Programming Manual
Installation & Wiring
Issue 2.7 5 July 2001 Page 8-7
════════════════╗ ╔══════════╗ ╔══════════╗ ╔══════════╗
J13 ║ ║ ║ ║ ║ ║ ║
┌┐ ║ LM0092 ║ ║ ║ ║ ║ ║
CONTROLLER │├──╨────┐ ║ ║ ║ ║ ║ ║
│├──╥──┐ │FRC ║ ║ ║ ║ ║ ║
└┘ ║ │ │ ║ ║ ║ ║ ║ ║
║ │ │ ║ ZONES ║ ─ ─ ─ ║ ZONES ║ ║ ZONES ║
════════════════╝ │ │ ║ 48 TO 64 ║ ║ 17 TO 32 ║ ║ 1 TO 16 ║
│ │ ║ ║ ║ ║ ║ ║
│ │ ║ EXT+ ║ RED ║ EXT+ ║ ║EXT ║
RED ┌───┼─┼────╫─o─o──────╫───────╫─o─o──────╫──╫─o LK1 ║
│ ┌─┼─┼────╫─o─o──────╫───────╫─o─o──────╫──╫─o FITTED ║
│ │ │ │ ║ - ║ BLACK ║ - ║ ║ ║
═════════════╗ │ │ │ │ ║ J1 J2 ║ ║ J1 J2 ║ ║ J1 J2 ║
║ │ │ │ │ ╚═╤═╤══╤═╤═╝ ╚═╤═╤══╤═╤═╝ ╚═╤═╤══════╝
J15 ║ │ │ │ └──────┘ │ │ └──── ─ ────┘ │ │ └──────┘ │
LED +o ──╫─┘ │ └──────────┘ └────── ─ ──────┘ └──────────┘
DISPLAY -o
──╫───┘ DISPLAY FRC
║BLACK
║
║ The order of the Display Boards is as viewed
MAF/PSU ║ from the rear (i.e. inside).
║
║
═════════════╝
FIG 8.1.3
DISPLAY BOARD CONNECTION
Note that a special loom (LM0092) is required to connect the first Display Board to the
Controller Board. This is included in the F3200 LED Display Kit (FZ3031).
For an NDU in New Zealand mode, if a NZ Display Extender board is fitted then it is added
to the end of the display board chain after the last 16 zone display board (if any) and link Lk1
on the last 16 zone display board must be NOT fitted. The NZ Display Extender does not
need a link fitted to it, its presence indicates to the NDU that it is the last board in the chain.
When programming the number of Display Bd, the Display Extender is not counted, but is
individually programmed as fitted/not fitted.
The Unprotected Termination board, PA0483, connects to the NZ Display Extender via FRC.
The NZ specific wiring connects to this Termination board.