Tyco F3200 - Manual (Page 87)

Document No: LT0122 F3200 Installation & Programming Manual
Programming
Issue 2.7 5 July 2001 Page 6-21
TEXT PROGRAMMING WITH A PC (CONTINUED)
The DELETE or BACKSPACE keys may be used to delete the last character typed, and the
ESCAPE key may be used to abort the text entry for the selected item.
After the ENTER key is pressed the message "Saved OK" will appear if the text has been
saved correctly into EEPROM.
To load a file of text names from the PC into the F3200 panel, the file should be set up as
shown in the following example. The names may actually be in any order, and it is not
necessary to have a name for every zone or relay, etc.
Ensure that the last name in the file is followed by a carriage return before the end of the file,
i.e. put a blank line at the end of the file.
The characters S, Z, R, etc, must always be in column 1 and the text names must also start
in column 1 (unless leading spaces are required, but this is unlikely).
S
40 character site name
(blank lines are allowed)
Z1
Example text name for zone 1
Z2
Name for zone 2
Z3
This name has leading spaces
Z4
This name does not have leading spaces
.
.
.
Z23
This name will be cut at 30 characters as it is too long
Z24
Name for zone 24
R1
Name for module relay 1
.
.
.
R64
Name for module relay 64
A1
Name for ancillary 1 relay
A2
Name for ancillary 2 relay
A3
Name for ancillary 3 relay
T1
Smoke
T4
Manual
T9
Therml (limited to six characters)