Tyco F3200 - Manual (Page 51)

Document No: LT0122 F3200 Installation & Programming Manual
Ordering Information
Issue 2.7 5 July 2001 Page 4-3
ORDERING INFORMATION (CONTINUED)
FP0712,FP,F3200 FIP,NO CARDFRAME,24 ZONE MAX,6A PSU
FP0713,FP,F3200,FIP,64 ZONE MAX,6A PSU
FP0714,FP,NETWORK DISPLAY UNIT (NDU),SLIMLINE,WALL MOUNT
FP0715,FP,NETWORK DISPLAY UNIT (NDU),FULL CAB & MAF/PSU
FP0731,FP,RDU TO NDU UPGRADE KIT
FP0733,FP,NETWORK DISPLAY UNIT,4U 19" RACK MTG,NO MAF/PSU
FP0749,FP,F3200 6A PSU UPGRADE KIT,1931-44
Kit to purchase to upgrade on existing panel to a 6A PSU.
FP0772,FP,REMOTE LCD DISPLAY (RDU),SLIMLINE,FLUSH MOUNT
Same as FP0559 except is a flush mounting cabinet.
FP0773,FP,NETWORK DISPLAY UNIT (NDU),SLIMLINE,FLUSH MOUNT
Same as FP0714 except is a flush mounting cabinet.
FP0774,FP,NDU,NETWORK DISPLAY,C/W I-HUB,SLIMLINE,SURFACE
Surface mount NDU, contains I-Hub for networking.
FZ3010,F3200,16 ZONE,STD CAB,NO CARDFRAME,NO LED,1U SHELF
(FP0550 with second 8ZM and 1U document shelf fitted)
FZ3024,F3200,8 ZONE,NO CARDFRAME,NO LEDS,7U BLANK,1U SHELF
(FP0550 with 7U blank hinged door and 1U document shelf fitted)
FZ3027,F3200,64 ZONE,C/W LEDS,1U SHELF
FZ3031,KIT,F3200,16 ZONE LED DISPLAY,LHS POSITION
(as per FP0475, but with 1.2m FRC, allows mtg of Display Bd in furthest left position.
Required for first display).
FZ3034,F3200,8 ZONE,NO CARDFRAME,NO LEDS,6A PSU
FZ3051,F3200,1 ZONE GAS CONTROL,SMALL CABINET
FZ9002,FP,19" RAC,7U BLANK INNER DOOR
FZ9009,KIT,19" RAC,3U AIU BRKT (mounts 2 Melbourne F.B. AIUs)
FZ9010,KIT 19" RAC,1U AIU BRKT (mounts 2 Melbourne F.B. AIUs)
(These include bracket and screws, etc, The 1U item is 1U at the front, but larger at the rear,
as required for F3200 small cabinet).
KT0072,KIT,F3200,CARDFRAME UPGRADE
KT0075,KIT,F3200,PSU UPGRADE,3A TO 6A,1931-44 (Factory fitted option only)
KT0111 KIT,1945-1-1,AS1668 CONTROL MODULE,TYPE 1 (refer PBG0015)
KT0112 KIT,1945-1-2,AS1668 CONTROL MODULE,TYPE 2 (refer PBG0015)
KT0113 KIT,1945-1-3,AS1668 CONTROL MODULE,TYPE 3 (refer PBG0015)
LM0041,LOOM,1888-58,PROG PORT TO 9 PIN SERIAL
(cable to connect printer/computer to Controller, has 9 pin min D)