Tyco F3200 - Manual (Page 84)

F3200 Installation & Programming Manual Document No: LT0122
Programming
Page 6-18 5 July 2001 Issue 2.7
6.4.3 TEXT ENTRY
The Text option allows entry of the following:
1. a 40 character name for the site
2. a 30 character name for each zone
3. a 30 character name for each module relay
4. a 30 character name for each ancillary relay
5. a 6 character name for each of the 9 programmable alarm text messages.
6. a 40 character fault action text.
7. a 12 character Tandem LCD password.
Text can be programmed with the keypad or with a PC connected to the Printer/Programmer
port (refer Section 6.4.3.2).
6.4.3.1 PROGRAMMING TEXT WITH THE KEYPAD
When an item (e.g. Zone 01) is selected, press "EDIT", "ENTER" or """ to enable text entry
for that item.
Text entry has two fields. The top field contains the text which has been entered and the
bottom field contains an array of characters which may be entered.
Each field has one of two cursors. The active cursor █ may be moved through the field it is
in by use of the ! " cursor keys to select a character, or position in text. The inactive cursor
$ shows where the active cursor would be if it was in that field.
Holding the ! " keys down causes rapid movement.
There is a choice of 3 lines of characters in the bottom field (upper case letters, lower case
letters, numbers and symbols). These may be scrolled by use of the # and % cursor keys
when the active cursor is in the bottom line. Note that numbers can be entered directly from
the keypad, and the "NOT" key inserts a blank space.
"EDIT" swaps the cursors between the two fields.
"INSERT" toggles entry between "insert" and "typeover" modes.
"DELETE"
acts as backspace for a character just entered, or deletes any character in the
text selected by the cursor (active or inactive).
"ACK"
saves the text and returns the cursor to the item number.
"NEXT" & step through items (e.g. zones).
"PREV"
"RECALL"
allows copying of the text from any zone or relay to any other zone or relay.
(Select zone/relay to be copied into. Press "RECALL" and select zone/relay
and number of zone/relay to be copied from. "ENTER" transfers the text.
This can then be edited).