Texas Instruments TMS320TCI648x - Manual (Page 111)

www.ti.com
5.2 Peripheral Identification Register (PID)
SRIO Registers
The peripheral identification register (PID) is a read-only register that contains the ID and ID revision
number for that peripheral. The PID stores version information used to identify the peripheral. Writes have
no effect to this register. The values are hard coded and will not change from their reset state.
The peripheral ID register (PID) is shown in Figure 63 and described in Table 41 .
Figure 63. Peripheral ID Register (PID) - Address Offset 0000h
31 24 23 16
Reserved TYPE
R-00h R-01h
15 8 7 0
CLASS REV
R-0Ah R-01h
LEGEND: R/W = Read/Write; R = Read only; -n = Value after reset
Table 41. Peripheral ID Register (PID) Field Descriptions
Bit Field Value Description
31–24 Reserved Reserved
23–16 TYPE Peripheral type: Identifies the type of the peripheral RIO
15–8 CLASS Peripheral class: Identifies the class Switch Fabric
7–0 REV Peripheral revision: Identifies the revision of the peripheral. This value should begin at 01h and be
incremented each time the design is revised .
SPRUE13A – September 2006 Serial RapidIO (SRIO) 111
Submit Documentation Feedback