Texas Instruments TMS320TCI648x - Manual (Page 130)

www.ti.com
5.15 SERDES Macro Configuration Register n (SERDES_CFGn_CNTL)
SRIO Registers
There are four of these registers, to support four ports (see Table 63 ). The general form for a SERDES
transmit channel configuration register is summarized by Figure 76 and Table 64 . See Section 2.3.2.1 for
a complete explanation of the programming of this register.
Table 63. SERDES_CFGn_CNTL Registers and the Associated Ports
Register Address Offset Associated Port
SERDES_CFG0_CNTL 0120h Port 0, Port 1, Port 2, and Port 3
SERDES_CFG1_CNTL 0124h Not Used. Program as
0x00000000
SERDES_CFG2_CNTL 0128h Not Used. Program as
0x00000000
SERDES_CFG3_CNTL 012Ch Not Used. Program as
0x00000000
Figure 76. SERDES Macro Configuration Register n (SERDES_CFGn_CNTL)
31 16
Reserved
R-0
15 10 9 8 7 6 5 1 0
Reserved LB Reserved MPY ENPLL
R-0 R/W-0 R-0 R/W-0 R/W-0
LEGEND: R/W = Read/Write; R = Read only; -n = Value after reset
Table 64. SERDES Macro Configuration Register n (SERDES_CFGn_CNTL) Field Descriptions
Bit Field Value Description
31–10 Reserved 0 Reserved
9–8 LB Loop bandwidth. Specify loop bandwidth settings. Jitter on the reference clock will
degrade both the transmit eye and receiver jitter tolerance thereby impairing system
performance. Performance of the integrated PLL can be optimized according to the
jitter characteristics of the reference clock via the LB field.
00b Frequency dependent bandwidth. The PLL bandwidth is set to a twelfth of the
frequency of RIOCLK/RIOCLK. This setting is suitable for most systems that input the
reference clock via a low jitter input cell, and is required for standards compliance
01b Reserved
10b Low bandwidth. The PLL bandwidth is set to a twentieth of the frequency of
RIOCLK/RIOCLK, or 3MHz (whichever is larger). In systems where the reference
clock is directly input via a low jitter input cell, but is of lower quality, this setting may
offer better performance. It will reduce the amount of reference clock jitter transferred
through the PLL. However, it also increases the susceptibility to loop noise generated
within the PLL itself. It is difficult to predict whether the improvement in the former will
more than offset the degradation in the latter.
11b High bandwidth. The PLL bandwidth is set to a eighth of the frequency of
RIOCLK/RIOCLK. This is the setting appropriate for systems where the reference
clock is cleaned through an ultra low jitter LC-based PLL. Standards compliance will
be achieved even if the reference clock input to the cleaner PLL is outside the
specification for the standard.
7–6 Reserved 0 Reserved
130 Serial RapidIO (SRIO) SPRUE13A – September 2006
Submit Documentation Feedback