Preface, Read this first – Texas Instruments TMS320TCI648x User Manual
Page 14
Preface
SPRUE13A – September 2006
Read This First
About This Manual
This document describes the Serial RapidIO
®
(SRIO) peripheral on the TMS320TCI648x™ devices.
Notational Conventions
This document uses the following conventions.
•
Hexadecimal numbers are shown with the suffix h. For example, the following number represents 40
hexadecimal (decimal 64): 40h.
•
Registers in this document are shown in figures and described in tables.
–
Each register figure shows a rectangle divided into fields that represent the fields of the register.
Each field is labeled with its bit name, its beginning and ending bit numbers above, and its
read/write properties below. A legend explains the notation used for the properties.
–
Reserved bits in a register figure designate a bit that is used for future device expansion.
Related Documentation From Texas Instruments
The following documents describe the C6000™ devices and related support tools. Copies of these
documents are available on the Internet at www.ti.com. Tip: Enter the literature number in the search box
provided at
www.ti.com
.
Implementing Serial RapidIO (SRIO) PCB Layout on a TMS320TCI6482 Hardware Design (literature
number
) specifies a complete printed circuit board (PCB) solution for the TCI6482 as well as a
list of compatible SRIO devices showing two DSPs connected via a 4x SRIO link. TI has performed the
simulation and system characterization to ensure all SRIO interface timings in this solution are met;
therefore, no electrical data/timing information is supplied here for this interface.
TMS320C6000 CPU and Instruction Set Reference Guide (literature number
gives an
introduction to the TMS320C62x™ and TMS320C67x™ DSPs, development tools, and third-party support.
TMS320C6000 Programmer's Guide (literature number
) describes ways to optimize C and
assembly code for the TMS320C6000™ DSPs and includes application program examples.
TMS320C6000 Code Composer Studio Tutorial (literature number
introduces the Code
Composer Studio™ integrated development environment and software tools.
Code Composer Studio Application Programming Interface Reference Guide (literature number
) describes the Code Composer Studio™ application programming interface (API), which allows
you to program custom plug-ins for Code Composer.
TMS320C64x+ Megamodule Reference Guide (literature number
describes the
TMS320C64x+ digital signal processor (DSP) megamodule. Included is a discussion on the internal direct
memory access (IDMA) controller, the interrupt controller, the power-down controller, memory protection,
bandwidth management, and the memory and cache.
TMS320TCI648x Bootloader User's Guide(literature number
describes the features of the
on-chip Bootloader provided with the TMS320TCI648x Digital Signal Processor (DSP). Included are
descriptions of the available boot modes and any interfacing requirements associated with them,
instructions on generating the boot table, and information on the different versions of the Bootloader.
Preface
14
SPRUE13A – September 2006