Texas Instruments TMS320TCI648x User Manual
Page 91
www.ti.com
4.3.4
Error, Reset, and Special Event Interrupt Condition Status and Clear Registers
Interrupt Conditions
Table 36. Interrupt Conditions Shown in LSU_ICSR and Cleared With LSU_ICCR (continued)
Bit
Associated LSU
Interrupt Condition
6
LSU1
Retry Doorbell response received or Atomic test-and-swap was not allowed (semaphore in
use)
5
LSU1
Transaction was not sent due to DMA data transfer error
4
LSU1
Transaction timeout occurred
3
LSU1
Transaction was not sent due to unsupported transaction type or invalid field encoding
2
LSU1
Transaction was not sent due to Xoff condition
1
LSU1
Non-posted transaction received ERROR response, or error in response payload
0
LSU1
Transaction complete, No errors (posted/non-posted)
(1)
The ICSR and the ICCR for the SRIO ports are shown in
. As described in
, each of the
nonreserved status and clear bits corresponds to a particular interrupt condition in one or more of the
SRIO ports. The ICS bits of ERR_RST_EVNT_ICSR indicate the occurrence of the conditions. The ICC
bits of ERR_RST_EVNT_ICCR are used to clear the corresponding ICS bits.
Figure 53. Error, Reset, and Special Event Interrupt Condition Status and Clear Registers
Error, Reset, and Special Event Interrupt Condition Status Register (ERR_RST_EVNT_ICSR) (Address Offset 0270h)
31
17
16
Reserved
ICS16
R-0
R-0
15
12
11
10
9
8
7
3
2
1
0
Reserved
ICS11
ICS10
ICS9
ICS8
Reserved
ICS2
ICS1
ICS0
R-0
R-0
R-0
R-0
R-0
R-0
R-0
R-0
R-0
Error, Reset, and Special Event Interrupt Condition Clear Register (ERR_RST_EVNT_ICCR) (Address Offset 0278h)
31
17
16
Reserved
ICC16
R-0
W-0
15
12
11
10
9
8
7
3
2
1
0
Reserved
ICC11
ICC10
ICC9
ICC8
Reserved
ICC2
ICC1
ICC0
R-0
W-0
W-0
W-0
W-0
R-0
W-0
W-0
W-0
LEGEND: R = Read only; W = Write only; -n = Value after reset
Table 37. Interrupt Conditions Shown in ERR_RST_EVNT_ICSR and Cleared
With ERR_RST_EVNT_ICCR
Bit
Interrupt Condition
31–17
Reserved
16
Device reset interrupt from any port
15–12
Reserved
11
Port 3 error (TMS320TCI6482 Only)
10
Port 2 error (TMS320TCI6482 Only)
9
Port 1 error
8
Port 0 error
7–3
Reserved
2
Logical layer error management event capture
1
Port-write-in request received on any port
0
Multi-cast event control symbol interrupt received on any port
SPRUE13A – September 2006
Serial RapidIO (SRIO)
91