Texas Instruments TMS320TCI648x - Manual (Page 93)

www.ti.com
4.4 Interrupt Condition Routing Registers
4.4.1 Doorbell Interrupt Condition Routing Registers
Interrupt Conditions
Table 38. Interrupt Clearing Sequence for Special Event Interrupts (continued)
Interrupt Function 1 st Step 2 nd Step 3 rd Step
Port 3 Error Write 1 to clear: Write 1 to clear any of the Write 1 to clear:
(TMS320TCI6482 Only) following possible bits:
Offset 0x0278 Offset 0x2100 Offset 0x14304
ERR_RST_EVNT_ICCR[11] SP3_ERR_STAT[2] – Fatal SP_CTL_INDEP[6]
error
SP3_ERR_STAT[25] – Failed
Threshold
SP3_ERR_STAT[24] –
Degraded Threshold
Offset 0x14304
SP3_CTL_INDEP[20] – Illegal
Transaction
SP3_CTL_INDEP[16] – Max
Retry Error
Device Reset Write 1 to clear: Write 1 to clear:
Offset 0x0278 Offset 0x12004
ERR_RST_EVNT_ICCR[16] SP_IP_MODE[2]
The interrupt conditions are programmable to select the interrupt output that will be driven. Using the
interrupt condition routing registers (ICRRs), software can independently route each interrupt request to
any of the interrupt destinations supported by the device. For example, a quad core device may support
four CPU servicing interrupt destinations, one per core (INTDST0 for Core0, INTDST1 for Core1,
INTDST2 for Core2, and INTDST3 for Core3). In addition, INTDST4 may be globally routed to all cores
and provide notification of a change in the one ICSR, while INTDST5 may be globally routed to all cores
and provide notification of a change in a different ICSR. The routing defaults for an interrupt condition
routing bit (ICRx) are given in
Table 39 .
Table 39. Interrupt Condition Routing Options
Field Access Reset Value Value Function
ICRx R 0000b 0000b Routed to INTDST0
0001b Routed to INTDST1
0010b Routed to INTDST2
0011b Routed to INTDST3
0100b Routed to INTDST4
0101b Routed to INTDST5
0110b Routed to INTDST6
0111b Routed to INTDST7
1111b No interrupt destination, interrupt source disabled
other Reserved
Figure 54 shows the interrupt condition routing registers for Doorbell 0. The other doorbell ICRRs have the
same bit field map, with the following addresses:
•
DOORBELL1_ICRR and DOORBELL1_ICCR2 (Address offsets 0290h and 0294h)
•
DOORBELL2_ICRR and DOORBELL2_ICRR2 (Address offset 02A0h and 02A4h)
•
DOORBELL3_ICRR and DOORBELL3_ICRR2 (Address offset 02B0h and 02B4h)
SPRUE13A – September 2006 Serial RapidIO (SRIO) 93
Submit Documentation Feedback