Texas Instruments TMS320TCI648x - Manual (Page 233)

www.ti.com
5.93 Port IP Prescaler Register (IP_PRESCAL)
SRIO Registers
The port IP prescaler register (IP_PRESCAL) is shown in Figure 156 and described in Table 178 . This
register defines a prescaler for different frequencies of the DMA clock. The purpose of this register is to
keep the timers of SP_LT_CTL (offset 01120h), SP0_ERR_RATE through SP3_ERR_RATE (offsets
02068h, 020A8h, 020E8, and 02128h), SP_IP_DISCOVERY_TIMER (offset 12000h), and
SP0_SILENCE_TIMER through SP3_SILENCE_TIMER (offsets 14008h, 14108h, 14208h, and 14308h)
within the same range for different frequencies of the DMA clock.
Figure 156. Port IP Prescaler Register (IP_PRESCAL) - Address Offset 12008h
31 16
Reserved
R-0000h
15 8 7 0
Reserved PRESCALE
R-00h RW-0Fh
LEGEND: R/W = Read/Write; R = Read only; -n = Value after reset
Table 178. Port IP Prescaler Register (IP_PRESCAL) Field Descriptions
Bit Field Value Description
31–8 Reserved 000000h These read-only bits return 0s when read.
7–0 PRESCALE For different frequencies of the DMA clock, use the following formula to get the prescaler value in
decimal, where the DMA clock frequency is in MHz:
DMA clock frequency x 16
156.25 – 1
06h 66.67 MHz
... ...
09h 100 MHz
... ...
0Fh 156.25 MHz
10h 166.67 MHz
... ...
18h 250 MHz
...
21h 333 MHz
SPRUE13A – September 2006 Serial RapidIO (SRIO) 233
Submit Documentation Feedback