Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 142)

User’s Manual
136
Setup Your Staking Options
9. Enter the first station that you want to stake
in the Station to Stake field.
10. Enter the desired spacing between the staked
stations in the Station Interval field.
11. In the Offset field, select L if you wish to
stake an offset on the left side of the curve, or
select
R if you wish to stake an offset on the
right side and enter the desired offset here.
(If you are not staking an offset, enter an
offset of zero.)
12. Tap the
92IIVHW / *UDGH button if you want to account for a
vertical offset or percent grade for the staked points and enter the
appropriate valued in the same field. When specifying a vertical
offset, you must also select the
D or U radio button to indicate
if the specified offset is downward or upward from the design
point, respectively.
13. Enter the current rod height in the Height of Rod field and tap
6ROYH!.
Aim the Total Station
14. Using the information displayed on the
screen, aim the total station toward the
design point and tap
6WDNH !. The graphic
portion of the screen shows the curve,
backsight direction and design point location
relative to the total station.